JRSC install question

[keebler65]

i'm still working on the install; its going pretty well. i do have a question though. i'm installing the oil separator box. i installed the PCV into the box, and attached the 18" 3/8" hose onto the other end of the PCV. then i installed th box. now the instructions say i need to connect the hose to the s tube. i see that fitting. next it says to tee the 3/8" hose for the purge cut valve. this is where i get confused. where does the 3rd part of the tee go to? i would assume it would go to either the charcoal canister, or the purge valve but the instructions arent clear as to which. furthermore, both of the things i just mentioned use hoses of a smaller diameter; close to the size of 1/4" hose. how would i connect that small hose to the 3/8" tee? i hope all this makes sense.


thanks

[solRNY]

well for my install, i inserted the PCV into the vacant spot on the oil sperator box, the "S" tube is the orginal PCV tube that connected the PCV to the intake manifold-use that same tube to connect it to the PCV and the nipple under the charger.

i did not have to do anything with the PURGE CUT VALVE, nothing at all.

i guess for your install-that you dont have the nipple for the PVC under the charger they want u to tee the vacum line for the purge and insert the PVC "S" tube there. i think

[keebler65]

so how is your purge valve hooked up then?

thanks

[RayRay000]

<BLOCKQUOTE><font size=2 face="Verdana, Helvetica, sans-serif">quote:</font><table border="0" width="90%" bgcolor="#333333" cellspacing="1" cellpadding="0"><tr><td width="100%"><table border="0" width="100%" cellspacing="0" cellpadding="2" bgcolor="#FF9900"><tr><td width="100%" bgcolor="#DDDDDD"><font size=2 face="Verdana, Helvetica, sans-serif">Originally posted by keebler65:
furthermore, both of the things i just mentioned use hoses of a smaller diameter; close to the size of 1/4" hose. how would i connect that small hose to the 3/8" tee? thanks</font></td></tr></table></td></tr></table></BLOCKQUOTE>

I run a mix of 5/16" I.D. Fuel Line and 3/8" I.D. hose for my catch can. From the stock PCV valve 5/16" fitted best, I think thats the OEM size.

<font color="#a62a2a" size="1">[ May 18, 2003 12:44 PM: Message edited by: RayRay000 ]</font>